Concrete Cleaning Penacola
Great Ideas and Information on Concrete Cleaning Basics
What You Need to Know About Concrete Cleaning in Pensacola
Cleaning concrete on a periodic basis will enhance its overall beauty and extend the service life of this hard material. It is often difficult when to decide when concrete requires cleaning as grime and dirt build-up is usually slow. However, after concrete cleaning, the results of cleaned concrete happen to be very noticeable.
There are several concrete cleaning methods which will depend on the surface type, which can include countertops, floors or exterior slabs. Each of these surfaces requires different procedures to prevent damaging the surface.
About Power Washing Concrete
In order to effectively clean concrete, the power washer should have a minimum rating of 3,000psi along with flow rates of a minimum of 4gpm (gallons per minute). Even though the pressures that are higher are often required for removing the tough contaminants like heavy tire-skid marks or paint, most contractors that use power-washing methods agree that 3,000psi is more than enough for just about any cleaning job.
Once the right water pressure has been determined, the flow rate will determine the speed of cleaning, and particularly how quickly the contaminants are flushed off the surfaces. Most contractors suggest the power washers that have volume outputs of 5 or 6gpm. When you clean a vertical surface, the high flow rate is not as important as gravity assists with the contaminants flowing down the surfaces.
The cleaning speed can also be increased when using the rotary nozzles as opposed to the standardized fan nozzles. When producing fan patterns, the standard nozzles work on deflecting the pressurized water at an angle, that allows the flow of water to slow down. On the other hand, the rotary nozzles spin un-deflected water jets in circular paths, which means the water is leaving the nozzle at a far greater speed.
To maximize cleaning speeds on flatwork areas, most of the manufacturers provide the wheel-mounted power washers which look like a lawn-mower. Inside the metal-housing are the nozzles that are mounted onto the spinning bars. When using a walk-behind washer, a worker can clean 3,000 square feet in as little as an hour as well as maintain the same productivity over the course of the day.
Is It Better To Use Cold Or Hot Water For Concrete Cleaning?
The cold-water power washer is generally lighter, cheaper and easier to use when compared to the hot-water units, which require a burner-system and heavy-heating coil in order to heat up the water. The cold-water washer units usually cost in the region of $2,000 and usually weigh around 200 pounds, while the hot-water units cost in the region of $3,000 and weigh over 400 pounds.
However, the hot water units clean a lot faster in comparison to the cold-water units. Even though the cold-water power washers are more than capable of removing dirt which is often more than enough for small and residential applications, the commercial power-washing contractors oftenbelieve that the use of hot water is well worth the expense. A reduction in labor costs offsets the costs of using hot water.
So for the best recommendations on what to do with your Concrete Cleaning issues in Pensacola FL, contact Beauchamp Power Washing Today at 850-602-5320